CAN ULC S536 04 PDF

ULC is pleased to announce the publication of the Fifth Edition of CAN/ULC- S, Standard for. Inspection and Testing of Fire Alarm Systems. This National. Fire Alarm Inspection, Maintenance, and Service by Anubis Systems Technologies. SCOPE. This Standard provides requirements for the inspection and testing of fire alarm systems and specifies the devices and functions to be inspected.

Author: Zunos Tudal
Country: Solomon Islands
Language: English (Spanish)
Genre: Photos
Published (Last): 16 May 2008
Pages: 500
PDF File Size: 5.4 Mb
ePub File Size: 2.32 Mb
ISBN: 220-1-91602-904-6
Downloads: 98143
Price: Free* [*Free Regsitration Required]
Uploader: Dogal

Daily Testing General – is the responsibility of the building management or an individual they’ve designated to perform these duties. Obstructive material discharged during s356 flow tests? T Output circuit alarm indicators operate. Where fault isolation in power distribution riser has been provided, tests have been conducted to ensure fan wire-to-wire short in the field wiring between each pair of control units or transponders, in C turn, results in annunciation of the fault and continued operation outside of the shorted section confirmed.

Identify conventional field device locations. Building diagrams are on site that clearly indicate the type and location of all smoke control equipment fans, dampers, etc. Heavy discoloration of water van drain test or plugging of inspectors test connection? Main Drain test shall be conducted on each system riser.

Intelligibility clarity of voice messages confirmed. Refer to Appendix F2 ; iv A battery capacity meter test. A specific reference to the Standard on the front page of the report i. Oil level in normal check sight glass Wet pit suction screens are unobstructed and properly installed Ilc of oil in sight glass? The tests reported on this form do not include the actual operational test of ancillary devices except where noted.

  DATA STRUCTURES THROUGH C SOLUTIONS BY YASHWANT KANETKAR PDF

Main drain test shall be conducted on each system riser. Backflow prevention assemblies shall be inspected locked or properly supervised by an acceptable electrical means.

CAN/ULC-S | Standards Council of Canada – Conseil canadien des normes

Heat detectors whose labels are missing, faded and unreadable, or painted are considered failed and require replacement. Testing results and any exceptions are identified in the Device Test Record. Interior of dry-pipe, pre-action and deluge valves cleaned? For more information you can email us or s563 Electrical components in service?

Free from mildew, cuts and deterioration? Emergency Power Supply Identification: Visual trouble signal operates. Smoke and fire detectors should ccan considered an integral part of any home or business security system. Good Worn Inspect electrically supervised valves? Steam from your hot bath, shower, or operating dishwasher may accidentally “set-off” one of these units. Automatic transfer from alert signal to alarm signal operates.

CAN/ULC-S536-04 Fire Alarm Annual Inspection Test Form

Output circuits for selective voice paging trouble operation, including visual G indication, operates. Is the building occupied? Fan of the area or fire zone protected by each alarm detection circuit this may be in the form of a list or plan uulc. Multi-line sequential display operates as per Appendix C5. Identify active field device and supporting field device, data communication link DCLaddress and location.

  100 NIJANSI SIVE PDF

Tests to be done every fifth year: Backflow prevention assemblies have been tested by an agency acceptable to 5s36 local authority? Confirm field device mechanically supported independently of the wiring. Y Ancillary device by-pass results in trouble signal.

No missing or damaged pipe support devices? Flame detectors inspected and tested. Two stage pull stations tested and functions confirmed? Alarm device, test on dry pipe, pre-action or deluge system using bypass? Maintenance Items Annually Hose nozzles – open and close and lubricate if necessary. Sprinklers shall be inspected from floor level? Jockey pump operational and in good condition?

Standards Council of Canada

Each device tested while connected to control unit? Recommended Additional Testing not mandated by the Standard: Visual signal appliances individually inspected and tested.

D B Terminal connections clean? Manual activation of alarm signal and indication operates. Test batteries for specific gravity and state of charge?

CAN/ULC-S Fire Alarm Annual Inspection Test Form

Operates on emergency power. Post indicator valves opened until spring or torsion is felt in rod. They incorporate an internal sounder and some also have a visible notification component strobe light to provide a localized alarm signal.

Yes No Oil Pressure: Diesel Natural Gas Other: Termination points for wiring to field devices secure. Advise fire department that testing is completed? Fire hose connection undamaged?

Author: admin